README file for the RTI Bypass Blockset Patch Vs. 2.6p3

December 15, 2009

Copyright (c) 2009 dSPACE GmbH, Germany
=======================================================================

-----------------------------------------------------------------------
This file contains information concerning

1. Introduction / Products revised by this Installation
2. How to install the customer support
3. Software changes
4. Restrictions

-----------------------------------------------------------------------

-----------------------------------------------------------------------
  1. Introduction / Products revised by this Installation
-----------------------------------------------------------------------

  This version has been created to work with:

  RTI Bypass Blockset version:
     RTI Bypass Vs. 2.6      (with Release 6.4 and 6.5)

-----------------------------------------------------------------------
  2. How to install the customer support
-----------------------------------------------------------------------

  The RTI Bypass Blockset Patch Vs. 2.6p3 software must be installed
  after the installation of the dSPACE standard software.

  NOTE: The RTI Bypass Blockset Patch Vs. 2.6p3 software installation
        requires the above listed version of the RTI Bypass Blockset
        to be installed prior to the patch installation.

  To install the RTI Bypass Blockset Patch Vs. 2.6p3 software please
  execute the RTIBypassVs.2.6p3.exe.

  NOTE: You need to close any dSPACE software and MATLAB before invoking
        the installation.

  The installation software also generates a file 'RTIBypassVs.2.6p3.dbg'
  in the Config directory of the dSPACE installation tree.

-----------------------------------------------------------------------
  3. Software changes
-----------------------------------------------------------------------

  - 2.6p3:
	[DCI-GSI1]
          * Fixes problem of 'Value Shift' to different block ports
            of 8 bit values when they are used in combination with 16bit 
            values (148486).

	[XCP]
          * Fixes problem of 'service command fail' error for
            'xcp_write_daq' command in some specific value constellations
            (149256).

  - 2.6p2:
	[Common]
          * Fixes problem that leads to no interfaces available in the
            "Bypass Interface Type" popup of the Setup block GUI when the
            logged on user has no administrator rights (147718)

  - 2.6p1:
	[Common]
          * Fixes problem with updating addresses on measurement array
            elements (147500)

-----------------------------------------------------------------------
  4. Restrictions
-----------------------------------------------------------------------

  This RTI Bypass Blockset Patch Vs. 2.6p3 software is restricted for
  the use with the RTI Bypass Blockset Version 2.6 on dSPACE Releases 
  6.4 and 6.5.

  The RTI Bypass Blockset Patch Vs. 2.6p3 software will not be installed
  for older or future versions of the dSPACE software.

  Please contact dSPACE for further information.

=======================================================================
End of File