dSPACE AutomationDesk 1.1p2                               January 2005
Last-Minute Information
======================================================================
Copyright (c) 2005 dSPACE GmbH, Germany

Contents:

1. General
2. Problems Fixed by this Patch
3. Limitations
4. Installing the Patch

======================================================================

1. General
----------------------------------------------------------------------
This patch can be installed on an existing AutomationDesk 1.1 
installation. It includes the AutomationDesk 1.1p1 patch.


2. Problems Fixed by this Patch
----------------------------------------------------------------------
All dialogs also work correctly on an operating system with a japanese language version.

This patch decreases the start-up time of AutomationDesk.
The loading time of AutomationDesk projects and libraries
is also reduced.


3. Limitations
----------------------------------------------------------------------
AutomationDesk projects and results must have been saved with 
AutomationDesk 1.1 without the patch (p2). 
AutomationDesk projects that were saved with 1.0 might be loaded 
incorrectly.

To load an AutomationDesk 1.0 project with AutomationDesk 1.1p2, you 
can perform the following steps:
- Close AutomationDesk.
- Deactivate the p2 patch by executing the DisableP2.reg registry file.
- Restart AutomationDesk 1.1p2. 
- Load the 1.0 project.
- Save the project and all included results.  
	Note: Results must be saved separately from the project.
- Close AutomationDesk.
- Reactivate the p2 patch by executing the EnableP2.reg registry file.
- Restart AutomationDesk 1.1p2.


4. Installing the Patch
----------------------------------------------------------------------
To install the patch, you must be logged on as an administrator.

Ensure that the active installation referenced by %DSPACE_ROOT%
contains AutomationDesk 1.1 or AutomationDesk 1.1p1. If you are unsure,
start dSPACE Installation Manager and check whether AutomationDesk 1.1
appears in the list of installed products for the active installation.

To install this patch, simply run AutomationDesk11p2.exe. The setup
will automatically locate and patch the active dSPACE installation.

After this patch is applied, the version of AutomationDesk on the splash
screen and in the About box is set to AutomationDesk 1.1p2.

----------------------------------------------------------------------
End of File